01
多人配合維修電梯時，要做到思想集中，相互之間有呼有應，做好配合工作。
02
如果要用三角鑰匙打開廳門，一定要看清楚轎廂的位置，不要想當然地認為電梯一定就在什么位置。
03
打開廳門進入轎頂時，不能立即關門，首先要把檢修開關置于檢修檔，按下急停開關，打開轎頂燈，在轎頂站穩后方能關上廳門。

04
出轎頂時，首先要打開廳門，再將轎頂檢修開關，急停開關，照明開關等一一復位，到達廳外后再關上廳門。（如果人站立在廳外能操作到以上開關，應站到廳外后再復位以上開關）
05
轎廂運行時，不要把身體探到攔桿之外。不要在騎跨處作業。
06
在轎頂時，萬一遇到電梯失控運行，千萬保持鎮定，應抓牢可扶之物，蹲穩在安全之處，不能企圖開門跳出。
07
在地坑工作時，應該切斷地坑檢修箱的安全開關。爬出地坑時，一定要保證廳門在打開狀態下，方能接通地坑的安全回路，然后迅速爬出地坑。（如果在廳外能操作安全開關，應在人爬出地坑后再接通安全開關，然后再關門）
08
如果必須要短接門鎖檢查電梯門鎖故障時，千萬要保證電梯處于檢修狀態。檢查完畢后，務必先斷開門鎖短接線后才能讓電梯復位到正常狀態。

09
檢修有應急裝置的電梯，在使用應急開關時，務必保證廳門處于關閉狀態，防止他人跌入井道。進入地坑工作，如果1樓門要開著，必須在廳門****警戒標志或專人看護，切實做好防止他人跌入地坑的措施。

10
當需要切斷電源檢修電梯時，應掛上“有人操作，禁止合閘”的警示牌。在進行帶操作或使用電動工具時，要切實做好防止觸電的安全事項。

01
Many people with the maintenance of the elevator, to do the ideological concentration, there is a call between each other, do a good job with the work.
02
If you want to use the triangle key to open the hall door, be sure to see the location of the car, do not take it for granted that the elevator must be in what position.
03
Open the hall door into the car top, can not immediately close the door, first of all to the maintenance switch placed in the repair file, press the emergency stop switch, open the car Ding Deng, in the car to stand before closing the door.

04
Out of the car top, the first to open the hall door, and then the car top overhaul switch, emergency stop switch, lighting switch, etc. one by one reset, after the arrival of the hall and then closed the door. (If the person standing outside the hall can operate to the above switch, should stand outside the office and then reset the above switch)
05
When the car is running, do not take the body out of the bar. Do not run around the ride.
06
In the car top, in case of runaway runaway control, do keep calm, should be able to grasp the matter, squatting in security, can not attempt to open the door out.
07
When working in the pit, the safety switch of the pit check box should be cut off. When climbing out of the pit, be sure to ensure that the door in the open state, can only connect the pit of the security circuit, and then quickly climbed out of the pit. (If you can operate the safety switch outside the hall, you should climb out of the pit and then turn on the safety switch, and then close the door)
08
If you have to short the door to check the elevator door lock failure, be sure to ensure that the elevator in the maintenance state. After checking, be sure to disconnect the door short before you can let the elevator reset to the normal state.
09
Check the elevator with the emergency device, when using the emergency switch, be sure to ensure that the door is closed, to prevent others fall into the shaft. Into the pit work, if the first floor of the door to be open, must be in the hall **** warning signs or personal care, do a good job to prevent others into the pit measures.
10
When you need to cut off the power maintenance elevator, you should hang "someone to operate, forbid closing" warning signs. When carrying out the operation or the use of electric tools, to do a good job to prevent electric shock safety matters.